TP-50V3 Tweeter Protector

The TP-50V3 is intended to protect your tweeters from electronic component failure, DSP software glitches or failures and erroneous crossover settings. The TP-50V3 will attenuate low frequency content from the amplifier and is only active below the crossover you implement in the DSP or the amplifier. 

The TP-50V3 will not protect against too much power above the crossover caused by bad gain setting procedure, or from the additional power at high frequencies contained in a severely clipped signal from a system component. The TP-50V3 will not cause "phase issues" because it is only active far below the crossover. 

The TP-50V3 is suitable for use with all Audiofrog tweeters. the TP-50V3 is not necessary when passive crossovers are used.

Included in Package:

• 2x TP-50V3
• 2x Tubes of Heat Shrink